©2020 Biological and Chemical Oceanography Data Management Office.This dataset presents the velocity and external sensor data recorded by the Nortek Vector ADV logger. The eddy covariance instrument was deployed July 11-17, 2017 in a subtropical inner shelf environment (Salinity: 35-36, temperature: 28-31°C) approximately 9 km south of Long Key in the Florida Keys (24° 43.52'N, 80° 49.85'W). The site was located at 9 ± 1 m water depth near the center of a large flat carbonate platform covered with coral sand. The measuring volume of the ADV was adjusted to be...
Show moreThe Nortek Vector ADV logger was deployed July 11-17, 2017 in a subtropical inner shelf environment (Salinity: 35-36, temperature: 28-31°C) approximately 9 km south of Long Key in the Florida Keys (24° 43.52'N, 80° 49.85'W). The site was located at 9 ± 1 m water depth near the center of a large flat carbonate platform covered with coral sand. The measuring volume of the ADV was adjusted to be ~35 cm above the sediment-water interface.
The velocity data are unprocessed raw data as recorded by the Nortek Vector ADV using the following settings.
Sampling rate: 64 Hz, down-averaged to 8Hz
Nominal velocity range: 0.30 m/s
Burst interval: CONTINUOUS
Samples per burst: N/A
Sampling volume: 14.9 mm
Measurement load: 59 %
Transmit length: 4.0 mm
Receive length: 0.01 m
Number of beams: 3
Software version: 1.37.02
Measurements and data analysis are reported in Huettel et al. (2020).
Known Problems:
Deployment 11-12 July: Measurements could not start before 14:00 due to bad weather preventing earlier deployment.
Huettel, M., Berg, P. (2021) Current flow, pressure, and oxygen concentrations recorded by the 3OEC-instrument in the Florida Keys from 11-17 July 2017. Biological and Chemical Oceanography Data Management Office (BCO-DMO). (Version 1) Version Date 2021-04-21 [if applicable, indicate subset used]. doi:10.26008/1912/bco-dmo.849934.1 [access date]
Terms of Use
This dataset is licensed under Creative Commons Attribution 4.0.
If you wish to use this dataset, it is highly recommended that you contact the original principal investigators (PI). Should the relevant PI be unavailable, please contact BCO-DMO (info@bco-dmo.org) for additional guidance. For general guidance please see the BCO-DMO Terms of Use document.